canoscan 9000f mark ii software not working

Which came with this software (README, FAQ, manpages). If you were expecting something different,Ĭheck that the scanner is plugged in, turned on and detected by the # Most Scanners connected to the parallel port or other proprietary ports # Not checking for parallel port scanners. # you have loaded a kernel driver for your USB host controller and have setup If you expected something different, make sure that # you have loaded a kernel SCSI driver for your SCSI adapter.Ĭould not fetch string descriptor: Pipe error # scanner is powered up and properly connected to your computer. # result is different from what you expected, first make sure your # sane-find-scanner will now attempt to detect your scanner. Linux-g8as:/home/john # sane-find-scanner The output from the two console commands that you suggest are:. I checked that the pixma backend is uncommented in /etc/sane.d/dll.conf and that I was a member of the lp user group. I have added the lines that you suggest to /etc/udev/rules.d/55 libsane rulesĪnd a corresponding line to etc/udev/rules.d/les. Please can anyone give advice? I get the same result if I use openSUSE 13.1. ID 04a9:190d whereas the udev/rules.d/55 libsane file gives If I look at file /etc/udev/rules.d/55 libsane rules it has two linesĪTTR='yes' When I open a console and type lsusb I getīus 001 Device 005: ID 04a9:190d Canon, Inc. When I select Hardware info in YaST I get (relevant bit) If I select this the response is pixma driver no scanner recognised. If I then select Add Scanner there is a lineĬanon CanoScan 9000F : (Package sane-backends) Driver pixma should provide complete functionality (USB-ID 0x04a9:0x1908) When I connect it and use YaST - hardware - scanner it says no scanner recognized. I have bought one since the Suse Hardware list says that it is fully supported.

Canoscan 9000f mark ii software not working